RPM Flare light load 3rd gear

Click on the "SUBSCRIBE" tab to sign up. I will not respond to technical questions unless you are a paid subscriber. Calibration and Config files will not open directly from the site, they must be downloaded to your computer in order to open.

NEW!!!

I will make one calibration change for an additional $100 per change. For example, changing a shift point for a given gear is $100 vs changing a shift point and a pressure setting would be $200. That value can be used towards the full custom tuning price.

1 post / 0 new

Mon, 09/04/2023 - 16:35

#1

wainfiggitty

RPM Flare light load 3rd gear

Hello,

Turbo 6.2 escalade, circle D stage 3 6l80, circle D 258mm billet tripple disc. I have it pretty dialed in, traps 125mph in quarter etc. I have one last issue I'm chasing down.

Intermittantly it will act like a false neutral going into 3rd gear at around 25% throttle. My scanner doesn't show any trans slip, input and output speeds look consistent, but rpm flares up to around 3600-4000 rpm.

The log shows TCC slip going up. I don't have any sign of converter failure...WOT works great, power breaking acts like it should etc.

Could this be something with the speed sensors? I'd think if that was an issue then there would be erratic shaft speeds....

I tried chaninging part throttle mph shift points.

3:10-3:12 minutes into the scan towards the end shows what I'm describing.

I'm kinda lost here.

Subscribe today to see the replies on this topic.

You are here

Click on the "SUBSCRIBE" tab to sign up. I will not respond to technical questions unless you are a paid subscriber. Calibration and Config files will not open directly from the site, they must be downloaded to your computer in order to open.

NEW!!!

I will make one calibration change for an additional $100 per change. For example, changing a shift point for a given gear is $100 vs changing a shift point and a pressure setting would be $200. That value can be used towards the full custom tuning price.